The Preparation Step That Decides How Evenly an Acid Treatment Performs
Pre-Peeling 50 ml is a professional preparatory formula applied by estheticians and skincare specialists right before an active acid treatment. Its role is to remove excess sebum, residual makeup and mineral deposits from the skin surface, creating an even canvas so the following acid product absorbs consistently across the whole treated area. This item belongs to the Peelings for Skin section, which brings together both active acid formulas and the supporting products used to apply them safely in a professional setting.
The primary field of use for pre-peeling products is professional esthetics and the spa industry: skincare studios, dermo-cosmetic clinics and salons offering chemical or device-assisted facial treatments. This preparatory stage largely determines whether an acid penetrates the stratum corneum evenly or leaves patchy, unpredictable results with localized irritation. The degreasing action works by gently dissolving the lipid film on the skin surface without over-drying it, which allows the formula to be used even on more reactive skin types. A secondary but growing use is home maintenance routines, where clients purchase the same preparatory step for touch-up treatments between salon visits.
Application is straightforward: the pre-peeling is spread in a thin layer over cleansed skin using a cotton pad, sponge or fan brush. Typical usage is between 2 and 5 ml per session, depending on the treated area. Contact time is short, usually one to three minutes, after which the product either evaporates on its own or is gently blotted away without rubbing. It is applied at room temperature and requires no heating step at any point in the protocol.
Compatibility with acid-based products is broad by design: it is commonly used ahead of the Retinol Peel 50 ml, before spot treatments with the Retinol Glycolic Peel 10 ml, and within multi-acid protocols built around ACB Fruit Mix 100 ml. Combining these products lets a specialist run a complete treatment protocol, from skin preparation through to barrier recovery at the end of the session.
The 50 ml format is sized for studio and salon workflows with a steady client volume, with a single bottle covering dozens of sessions thanks to the low usage rate per treatment. Store the product in a cool, shaded place away from direct sunlight and heat sources, keeping the bottle tightly closed after each use to prevent evaporation of volatile components and changes in the working concentration.
Two-step brightening protocol for studio use
Pre-Peeling 5 ml
ACB Fruit Mix 12 ml
Alcohol-free toner 15 ml
Soothing hydrogel 20 ml
Cleanse
the skin and wipe it with the alcohol-free toner, then apply the pre-peeling in
a thin layer with a sponge and leave it for two minutes to break down the lipid
barrier. Once it has evaporated, brush on the ACB Fruit Mix in an even layer,
hold for the exposure time set by the treatment protocol, neutralize with
room-temperature water, and finish with the soothing hydrogel to support the
skin barrier after the session.